Vehicle load label

Use alcohol to clean the position to paste, dry, keep the surface dry, no water, oil, dust, try not to finish the paste before the vehicle wax.

When attaching the vehicle load label, choose a flat place according to the size of the vehicle paste, and then remove the backing paper on the back of the vehicle label (when attaching, heat the rubber surface with a hair dryer to make it more sticky. Paste directly, pressing with your hand.

Note: Once pasted, try not to move, and do not immediately pull by hand to test the firmness of the paste, so it is easy to pull bad glue, do not wash the car for 3 days after pasting.

1. The safe way: Make a small slit diagonally from the side of the bubble with a utility knife, then smooth it with a scraper and a baking gun.

2. Tear it in half and slowly stick it on.

3. Prick the bubble with a needle and press flat.

4 Dry paste method, it is inevitable that there will be bubbles, don't panic ~ small two, I will tell you the solution: first squeeze small bubbles with your fingers, try to squeeze a piece. Then with a needle, or for the head of an art knife, give it a gentle poke and press with your fingers and the bubbles will disappear. You can ignore the little bubbles. In the sun for 1-2 days, as the temperature rises, the air inside will escape from the material!